Formulario de Pedido Fotos Quilhas Construção do Casco Convés Mastro e asteiamento Plano Vélico Lista de Planos Principais Dimensões Layout Descrição

Pop 20

Les projets séront écrits en anglais ou portuguais.

The plans for building the Pop 20 are a sort of kit on paper. All the transverse structural components as well as the stem are given in full size patterns and the other plans show in details how all major components are defined. If CNC cutting is preferred, we can provide the file in CD-Rom instead of the full size patterns The plans are so simple to be understood that written explanations are practically unnecessary.

The full size patterns for cross sections of transverse structure include external and internal cut-outs, discounted sheathing thickness. These transverse structures are made of 15mm (5/8") marine plywood and all it's required to make them is to transfer the full size lines to the plywood and cut it with the jigsaw, the other option being laser cutting. It's even provided a temporary support base on top of each deck beam to attach each bulkhead to the building grid. Notches for longitudinal components, like chines, sheer clamps and stringers are also defined in the full size patterns in their correct positions.
The stem is built using four plywood cut-outs, which are given in full size in a specific sheet, glued one to each other, building up the thickness required for this component of the structure. The forestay chain plate is inserted between the two internal pieces, so it requires no complicate procedures to install this important equipment.

The stem attaches to bulkhead 0 by means of a notch shown in full scale at bulkhead 0, so these two components become firmly fixed one to the other, providing a rigid base to hold the other structural members
After placing the pre-fabricated structure on the building grid, the longitudinal componentents are nailed and glued into their notches at each bulkhead and a plywood keel is laminated in place over the bulkhead floors.
Beveling and fairing required are easily performed and the plywood sheathing is quite easy to be applied, considering that the plywood thickness is only 6mm (1/4")
After applying the plywood sheathing, the hull is covered with two layers of 450g/m2 mat saturated in epoxy resin. The interior is already defined by the transverse structure and requires very little work to be completed. The whole interior must be saturated with two coats of epoxy resin to seal the plywood from moisture, this way assuring a long life to the boat.

Deck is even more straightforward and it also is encapsulated in two layers of 450g/m2 mat saturated in epoxy.
Keel and other fittings are bolted in place and for that matter it's specified the wooden reinforcements that work as back plates for them.

bulkheads

15 mm plywood

stem

2x 15 mm and 2 x 10 mm plywood

Keel

3 x 10 mm plywood

Chines

40 mm x 20mm wooden strips

Sheer Clamps

2 x 40 mm x 20mm wooden strips

Stringers

20 mm x 20mm wooden strips

Hull sheathing

6 mm plywood

Deck sheathing

6 mm plywood

Hull fibreglass sheathing

3 x mat 450g/m2

Deck fibreglass sheathing

2 x mat 450g/m2

Longitudinal furniture

10 mm plywood

Floor boards

10 mm plywood

cockpit floor board

10 mm plywood

bunk boards

6 mm plywood

Furniture structure

20 mm x 20mm cleats

Floors

40 mm thick wooden cleats

central deck stringer

50 mm x 20mm cleats

Deck stringers

20 mm x 20mm cleats

Underdeck reinforcements

wooden 20 mm thickness

transom

15 mm plywood